Glossary entry (derived from question below)
Japanese term or phrase:
つぶし率(O-ring)
English translation:
squeeze rate
Added to glossary by
cinefil
Apr 28, 2010 00:31
14 yrs ago
2 viewers *
Japanese term
つぶし率
Japanese to English
Tech/Engineering
Mechanics / Mech Engineering
This term is associated with O ring.
つぶし率を大きくとり過ぎるとOリングの破損の原因になることやはみ出しを起こすことがありますので注意が必要です。
Please help. Thanks.
つぶし率を大きくとり過ぎるとOリングの破損の原因になることやはみ出しを起こすことがありますので注意が必要です。
Please help. Thanks.
Proposed translations
(English)
| 3 | squeeze rate |
cinefil
|
References
| O-Ring Glossary |
dosanko
|
Change log
May 20, 2010 23:21: cinefil Created KOG entry
Proposed translations
10 mins
Selected
squeeze rate
The first loading condition is the case in which uniform squeeze rates are applied to the upper side and the lower side of the O-ring (the strain condition).
http://www.springerlink.com/content/pv8u1k366831n8g0/
http://www.packing.co.jp/ORING/oringmizosunpou11.htm
http://pg.jisw.com/01160/oo.html
http://www.springerlink.com/content/pv8u1k366831n8g0/
http://www.packing.co.jp/ORING/oringmizosunpou11.htm
http://pg.jisw.com/01160/oo.html
4 KudoZ points awarded for this answer.
Comment: "Thanks."
Reference comments
4 hrs
Reference:
O-Ring Glossary
SQUEEZE - compression of an O-ring’s cross-section between mating surfaces; noted as both a decimal measurement (in inches and/or millimeters) and as a percentage of the original cross-section (width). Radial compression occurs on the outside diameter (O.D.) and inside diameter (I.D.). Axial compression occurs on the top and bottom surfaces.
Something went wrong...